Drive Belt: Installation
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FAN AND GENERATOR V BELT
- Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the fan and generator V belt.
SST 09216-42010
NOTE:- Be sure to connect SST and the tools so that they are in line during use.
- When retracting the tensioner, turn it clockwise slowly for 3 seconds or more. Do not apply force rapidly.
- After the tensioner is fully retracted, do not apply force any more than necessary.
- Using SST and 19 mm socket wrench, loosen the V-ribbed belt tensioner arm clockwise, then install the fan and generator V belt.
- INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
- Install the reinforcement RH with the 4 bolts.
Torque: 96 N*m (979 kgf*cm, 71 ft.*lbf)
- Install the reinforcement RH with the 4 bolts.
- INSTALL FRONT FENDER APRON RH
- INSTALL FRONT WHEEL RH
- INSTALL RADIATOR SUPPORT OPENING COVER