Brake Pedal: Inspection
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT STOP LIGHT SWITCH ASSEMBLY
- Measure the resistance of the switch.
Standard resistance
STOP LIGHT SWITCH ASSEMBLY
| Tester Connection |
Switch Condition |
Specified Condition |
| 1 - 2 |
Switch pin released |
Below 1 |
| 1 - 2 |
Switch pin pushed in |
10 k or higher |
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
If the result is not as specified, replace the stop light switch assembly.