LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Brakes - Mechanical) >> Brake Master Cylinder >> Disassembly

Brake Master Cylinder: Disassembly

WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • The master cylinder and piston are designed so that the piston can easily fall out. Prevent this by making sure to tip of the master cylinder points downward when handling the master cylinder.
  • Make sure foreign matter does not attach to the master cylinder's piston. If foreign matter attaches, clean it off with a cloth. Then apply lithium soap base glycol grease to the entire outer circumference contact surface area of the piston.
  1. REMOVE BRAKE MASTER CYLINDER RING PIN 
  2. REMOVE BRAKE MASTER CYLINDER RESERVOIR SUB-ASSEMBLY 
  3. REMOVE MASTER CYLINDER RESERVOIR GROMMET 
  4. REMOVE BRAKE MASTER CYLINDER RESERVOIR FILLER CAP ASSEMBLY 
  5. REMOVE BRAKE MASTER CYLINDER RESERVOIR STRAINER 
scientia non olet · About LEMON Manuals