2GR-FE Engine Mechanical: Equipment
WARNING: This page is about a different car, the 2008 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
EQUIPMENT DESCRIPTION
| Alignment tester | - |
| Angle gauge | - |
| Brass bar | - |
| Caliper gauge | - |
| Chain block | - |
| Compression gauge | - |
| CO/HC meter | - |
| Connecting rod aligner | - |
| Cylinder gauge | - |
| Dial indicator with magnetic base | - |
| Engine stand | - |
| Feeler gauge | - |
| Gasket scraper | - |
| Magnetic finger | - |
| Micrometer | - |
| Needle-nose pliers | - |
| No. 1 engine hanger | - |
| No. 2 engine hanger | - |
| Pin hole grinder | - |
| Piston ring compressor | - |
| Piston ring expander | - |
| Piston heater | - |
| Plastigage | - |
| Plastic-faced hammer | - |
| Press | - |
| Radiator cap tester | - |
| Reamer (5.5 mm) | - |
| Ridge reamer | - |
| Rod aligner | - |
| Sandpaper (#400) | - |
| Slide calipers | - |
| Straightedge | - |
| Spring scale | - |
| Spring tension gauge | - |
| Steel square | - |
| Tachometer | - |
| Timing light | - |
| Toe-in gauge | - |
| Torque wrench | - |
| Valve seat cutter | - |
| V-block | - |
| Vernier calipers | - |
| Vise | - |
| Wooden block | - |