Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

When using the intelligent tester, start form *1 if the VSC TRAC warning light does not light up, or start form *3 if the VSC TRAC warning light remains on.
When not using the intelligent tester, start form *2 if the VSC TRAC warning light does not light up, or start form *4 if the VSC TRAC warning light remains on.

PERFORM ACTIVE TEST BY INTELLIGENT TESTER (WARNING LIGHT)*1

Select the ACTIVE TEST, generate a control command, and then check that the VSC TRAC warning light operates.

Skid control ECU

ACTIVE TEST REFERENCE

Item	Vehicle Condition / Test Details	Diagnostic Note
VSC TRAC WARN LIGHT	Turn VSC TRAC warning light ON / OFF	Observe combination meter

OK: VSC TRAC warning light turns on or off.

OK: REPLACE SKID CONTROL ECU ASSEMBLY

NG: GO TO Next Step

CHECK VSC TRAC WARNING LIGHT*2
1. Disconnect the A42 ECU connector.
2. Turn the ignition switch ON.
3. Using a service wire, connect terminal WA to GND3 or GND4 of the A42 ECU connector. Check the VSC TRAC warning light.
  OK: VSC TRAC warning light turns off.
4. Turn the ignition switch OFF.
5. Remove the service wire.
6. Turn the ignition switch ON. Check the VSC TRAC warning light.
OK: VSC TRAC warning light illuminates.

OK: REPLACE SKID CONTROL ECU ASSEMBLY

NG: GO TO Next Step

INSPECT RELAY (Marking: IG1 NO. 2)

Remove the IG1 NO. 2 relay from the cowl side junction block LH.
Measure the resistance of the relay.

Standard resistance

RESULT REFERENCE CHART

Tester Connection	Specified Condition
1 - 2	10 kΩ or higher
1 - 2	Below 1 Ω (when battery voltage is applied to terminals 3 and 4)

NG: REPLACE RELAY

Fig 1: Identifying IG1 NO. 2 Relay From Cowl Side Junction Block LH

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: CHECK COMBINATION METER (COMBINATION METER CIRCUIT)

INSPECT SKID CONTROL ECU CONNECTOR*3
1. Check that each ECU connector is properly installed.
OK: Each ECU connector is properly installed.

NG: CONNECT CONNECTOR TO ECU CORRECTLY

OK: GO TO Next Step

PERFORM ACTIVE TEST BY INTELLIGENT TESTER (VSC TRAC WARNING LIGHT)

Select the ACTIVE TEST, generate a control command, and then check that the VSC TRAC warning light operates.

Skid control ECU

ACTIVE TEST REFERENCE CHART

Item	Vehicle Condition / Test Details	Diagnostic Note
VSC TRAC WARN LIGHT	Turn VSC TRAC warning light ON / OFF	Observe combination meter

OK: VSC TRAC warning light turns on or off.

OK: REPLACE SKID CONTROL ECU ASSEMBLY

NG: GO TO Next Step

CHECK FOR DTC*4

Turn the ignition switch ON.
Check that the VSC TRAC warning light illuminates.
Check if the same DTCs are recorded.

Result:

RESULT REFERENCE CHART

Result	Proceed to
DTC is not output	A
DTC is output	B

B: REPAIR CIRCUIT INDICATED BY OUTPUT DTC

A: GO TO Next Step

CHECK WIRE HARNESS (SKID CONTROL ECU ASSEMBLY - COMBINATION METER)
NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

OK: REPLACE SKID CONTROL ECU ASSEMBLY