Rear Speed Sensor: Removal: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

Fig 1: Identifying Bolt And Speed Sensor

INSTALL REAR SPEED SENSOR LH
1. Install the speed sensor with the bolt.
  Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf)
  
  NOTE: Keep the sensor tip and sensor installation hole free from foreign matter.
2. Install the sensor wire harness to the frame, upper control arm and axle housing with the 6 resin clips.
  NOTE: Do not twist the sensor wire when installing it.
3. Install the clamp bolt to the upper control bracket.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
  
  NOTE: Do not twist the sensor wire when installing it.
  
  Fig 2: Installing Speed Sensor With Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Connect the speed sensor connector.
NOTE: Do not twist the sensor wire when installing it.
INSTALL REAR WHEEL
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
CHECK ABS SPEED SENSOR SIGNAL
1. Check the ABS speed sensor signal (see DIAGNOSIS SYSTEM ).
Fig 3: Connecting Speed Sensor Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002