LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 145 (Tire & Wheel) >> Tire Pressure Warning Antenna >> Installation

Tire Pressure Warning Antenna: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY 
    1. w/ Tire pressure warning antenna:
      1. Install the rear view mirror (see INSTALLATION
  2. INSTALL TWEETER SPEAKER 
    1. Install the tweeter speaker (see INSTALLATION ).
  3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY 
    1. Install the trim board (see INSTALLATION ).
  4. INSTALL FRONT DOOR COURTESY LIGHT ASSEMBLY 
    1. Install the courtesy light (see INSTALLATION ).
  5. INSTALL NO. 1 DOOR INSIDE HANDLE BEZEL 
    1. Install the inside handle bezel (see INSTALLATION ).
  6. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL 
    1. Install the inside handle bezel (see INSTALLATION )
  7. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY 
    1. Install the regulator switch (see INSTALLATION ).
  8. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH 
    1. Install the lower frame bracket garnish (see INSTALLATION ).
  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  10. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.