Throttle Body: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
DRAIN ENGINE COOLANT (See REPLACEMENT )
REMOVE V-BANK COVER SUB-ASSEMBLY (see REMOVAL )
REMOVE INTAKE AIR CONNECTOR PIPE (see REMOVAL )
REMOVE THROTTLE BODY
1. Disconnect the throttle position sensor and control connector.
2. Disconnect the 2 water bypass hoses.
  
  Fig 1: Locating Water By-Pass Hoses
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the 3 bolts, nut, throttle body and gasket.
Fig 2: Locating Bolts, Nut And Throttle Body
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002