LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Control System (2UZ-FE)) >> SFI System >> DTC P1613 Secondary Air Injection Driver Malfunction >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

All: 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever these DTCs are not present -

Case 1: 

TYPICAL ENABLING CONDITIONS CHART

Battery voltage 8 V or more
Ignition switch ON
Starter OFF

Case 2: 

TYPICAL ENABLING CONDITIONS CHART

Either of following conditions is met Condition 1 or 2
1. Air pump Not operating
2. Air switching valve Not operating
Battery voltage 8 V or more
Ignition switch ON
Starter OFF

Case 3: 

TYPICAL ENABLING CONDITIONS CHART

Air pump Operating
Air switching valve Operating
Battery voltage 8 V or more
Ignition switch ON
Starter OFF

Case 4: 

TYPICAL ENABLING CONDITIONS CHART

Battery voltage 8 V or more
Ignition switch ON
Starter OFF