LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Control System (2UZ-FE)) >> SFI System >> DTC P1340 Camshaft Position Sensor "A" (Bank 1 Sensor 2) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS

The monitor will run whenever these DTCs are not present -

Camshaft position sensor range check: 

TYPICAL ENABLING CONDITIONS CHART

Starter ON
Minimal battery voltage while starter ON Less than 11 V

Camshaft position / Crankshaft position misalignment: 

TYPICAL ENABLING CONDITIONS CHART

Engine RPM 600 rpm or more
Starter OFF