LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Engine Control System (2UZ-FE)) >> SFI System >> DTC P0340 Camshaft Position Sensor Circuit Malfunction: DTC P0345 Camshaft Position Sensor "A" Circuit (Bank 2) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

All: 

TYPICAL ENABLING CONDITIONS

Monitor will run whenever these DTCs are not present None

P0340, P0345 Case1: 

TYPICAL ENABLING CONDITIONS CHART

Starter ON
Minimal battery voltage while starter ON Less than 11 V

P0340, P0345 Case 2: 

TYPICAL ENABLING CONDITIONS CHART

Engine RPM 600 rpm or more
Starter OFF
Battery voltage 8 V or more
Ignition switch ON