LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - A750F) >> Park / Neutral Position Switch >> Removal

Park / Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. DISCONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR 
  3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Using a screwdriver, pry out the lock Washer.
    2. Remove the lock nut and lock washer.
    3. Remove the bolt and park/neutral position switch.
    Fig 1: Locating Lock Nut And Lock Washer
    G04963368Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals