Park / Neutral Position Switch: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Install the park/neutral position switch to the manual valve shaft.
2. Temporarily install the bolt.
3. Install a new lock washer and the nut.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
  
  Fig 1: Locating Lock Washer And Lock Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Turn the control shaft fully rearward, and return the control shaft lever 2 notches to the N position.
  
  Fig 2: Adjusting Control Shaft Lever To N Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Align the neutral basic line with the switch groove, and tighten the bolt.
  Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
6. Using a screwdriver, bend the tabs of the lock washer.
Fig 3: Identifying Park/Neutral Position Switch Groove
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT PARK/NEUTRAL POSITION SWITCH CONNECTOR
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
INSPECT SHIFT LEVER POSITION
ADJUST SHIFT LEVER POSITION
INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Inspect park/neutral position switch assembly (see PARK / NEUTRAL POSITION SWITCH ).