Park / Neutral Position Switch: Inspection

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT PARK/NEUTRAL POSITION SWITCH

Disconnect the PNP switch connector.
Measure the resistance of the PNP switch when the shift lever is moved to each position.

Fig 1: Identifying PNP Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Shift Lever Position	Specified Condition
4(B) - 5(L)	P or N	Below 1 Ω
4(B) - 5(L)	Not on P or N	10 kΩ or higher
1 (RL) - 2 (RB)	R	Below 1 Ω
1 (RL) - 2 (RB)	Not on R	10 kΩ or higher
2 (RB) - 7 (DL)	D	Below 1 Ω
2 (RB) - 7 (DL)	Not on D	10 kΩ or higher
2 (RB) - 3 (2L)	2	Below 1 Ω
2 (RB) - 3 (2L)	Not on 2	10 kΩ or higher
2 (RB) - 8 (LL)	L	Below 1 Ω
2 (RB) - 8 (LL)	Not on L	10 kΩ or higher