Floor Shift Assembly: Installation

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FLOOR SHIFT LEVER ASSEMBLY
1. Install the floor shift lever assembly with the 6 bolts.
  Torque: 8.3 N*m (85 kgf*cm, 73 in.*lbf)
2. Connect the connector to the floor shift lever assembly.
Fig 1: Locating Floor Shift Lever Assembly Bolts
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY
1. Shift into the N position.
2. Connect the No. 1 floor shift gear shifting rod and connecting rod swivel with the nut.
Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)
INSTALL CONSOLE PANEL SUB-ASSEMBLY UPPER
1. Install console panel sub-assembly upper (see INSTALLATION ).
Fig 2: Locating Floor Shift Gear Shifting Rod Nut
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY