Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT)

Disconnect the E1 wire connector.
Measure the resistance of the transmission wire.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
14 (SLT+) - 6 (SLT-)	20°C (68°F)	5.0 to 5.6 Ω
14 (SLT+) - Body ground	20°C (68°F)	10 kΩ or higher
6 (SLT-) - Body ground	20°C (68°F)	10 kΩ or higher

NG: GO TO step 3

Fig 1: Identifying Transmission Wire Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step

CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM)

Disconnect the E6 ECM connector.
Measure the resistance of the wire harness side connector.

Standard resistance

RESISTANCE SPECIFICATION

Tester Connection	Condition	Specified Condition
E6-13(SLT+) - E6-12 (SLT-)	20°C (68°F)	5.0 to 5.6 Ω
E6-13(SLT+) - Body ground	20°C (68°F)	10 kΩ or higher
E6-12 (SLT-) - Body ground	20°C <68°F)	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

Fig 2: Disconnecting E6 ECM Connector

OK: REPLACE ECM

INSPECT SHIFT SOLENOID VALVE SLT
1. Remove the shift solenoid valve SLT.
2. Measure the resistance of the solenoid valve.
  Standard resistance: 5.0 to 5.6 Ω at 20°C (68°F)
3. Connect the battery's positive (+) lead to the terminal of the solenoid connector, and the negative (-) lead to the solenoid body.
OK: Solenoid makes operating noise.

NG: REPLACE SHIFT SOLENOID VALVE SLT

Fig 3: Measuring Resistance Between Shift Solenoid Valve SLT Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPAIR OR REPLACE TRANSMISSION WIRE