LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 143 (Automatic Transmission - A750F) >> Automatic Transmission System >> DTC P0894 Transmission Component Slipping; DTC P2714 Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT) >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

All 

TYPICAL ENABLING CONDITIONS

The monitor will run whenever this DTC is not present. None
Turbine speed sensor (NT) circuit Not circuit malfunction
Output speed sensor (NO) circuit Not circuit malfunction
TFT temperature sensor circuit Not circuit malfunction
Shift solenoid valve S1 circuit Not circuit malfunction
Shift solenoid valve S2 circuit Not circuit malfunction
Shift solenoid valve SR circuit Not circuit malfunction
Shift solenoid valve SL1 circuit Not circuit malfunction
Shift solenoid valve SL2 circuit Not circuit malfunction
Shift solenoid valve SLT circuit Not circuit malfunction
ECT (Engine Coolant Temperature) sensor circuit Not circuit malfunction
KCS sensor circuit Not circuit malfunction
ETCS (Electric Throttle Control System) Not system down
Transmission range "D"
ECT 40°C(104°F) or more
Spark advance from Max. retard timing by KCS control 0° crankshaft angle or more
Engine Starting
Transfer range "High" *1
TFT temperature 10°C(50°F) or more

Transfer range "HIGH" *1 (This condition is applied only 4WD) 

*1: Following conditions met

TYPICAL ENABLING CONDITIONS

Vehicle speed sensor circuit Not circuit malfunction
Output shaft speed sensor circuit Not circuit malfunction
Transfer output speed 143 rpm or more
NO/NOtf (Transfer input speed/Transfer output speed) 0.9 to 1.1