LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Engine Control System (2AZ-FE)) >> SFI System >> DTC P0500 Vehicle Speed Sensor "A" >> Typical Enabling Conditions

Typical Enabling Conditions

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
TYPICAL ENABLING CONDITIONS

Monitor runs whenever following DTCs not present P0120 - P0223, P2135 (TP sensor)
Either of following conditions (a) or (b) met: -
(a) Following conditions 1 and 2 met: -
1. ECT and ECT sensor 20°C (68°F) or more, and sensor does not malfunction (P0115 or P0116)
2. Time after PNP switch turned OFF 10 seconds or more
(b) Following conditions 1 and 2 met: -
1. ECT and ECT sensor Less than 20°C (68°F), and sensor malfunction (P0115 or P0116)
2. Time after PNP switch turned OFF 30 seconds or more
Time after ignition switch turned ON More than 0.5 seconds