Camshaft Timing Oil Control Valve Assembly: Inspection

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

Measure the resistance of the oil control valve.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION

Tester Connection	Specified Condition
1 (+B) - 2 (GND)	6.9 to 7.9 Ω at 20°C(68°F)

If the result is not as specified, replace the oil control valve assembly.

Fig 1: Measuring Resistance Of Oil Control Valve

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Check the operation.

Connect the battery's positive (+) lead to terminal 1 and negative (-) lead to terminal 2, and check the movement of the valve.

TERMINALS SPECIFIED CONDITION CHART

Condition	Specified Condition
Battery positive (+) voltage is applied	Valve moves in black arrow direction shown in illustration
Battery positive (+) voltage Is cut off	Valve moves in white arrow direction shown in illustration

Fig 2: Checking Operation - Spool Valve

NOTE: Check that the spool valve is not stuck.

HINT:

The spool valve may not return if foreign objects are caught in it. This may cause subtle pressure leaks to the advance side, and a DTC may be set.