Spiral Cable: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).

INSTALL SPIRAL CABLE SUB-ASSEMBLY
1. Check that the front wheels are facing straight ahead.
2. Set the turn signal switch to the neutral position.
  NOTE: Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.
3. Install the spiral cable.
  
  Fig 1: Identifying Spiral Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  NOTE: When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.
4. Connect the connectors to the spiral cable.
  NOTE: When handling the airbag connector, do not damage the airbag wire harness.
  
  Fig 2: Connecting Connectors To Spiral Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Attach the 4 clips to the column cover (upper).
  
  Fig 3: Identifying Column Cover (Upper) Clips
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Install the steering column cover (upper).
Fig 4: Identifying Steering Column Cover (Upper)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING COLUMN COVER (LOWER)
1. Attach the 4 claws.
Fig 5: Identifying Steering Column Cover (Lower) Claws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
POSITION SPIRAL CABLE
1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.
  NOTE: Do not use the airbag wire harness to turn the spiral cable.
  
  Fig 6: Rotating Spiral Cable Counterclockwise
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
NOTE: Do not use the airbag wire harness to turn the spiral cable.

HINT:

The spiral cable will rotate approximately 2.5 turns to the left and right from the center.

Fig 7: Rotating Spiral Cable Clockwise
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING WHEEL ASSEMBLY (see )
INSTALL STEERING PAD ASSEMBLY (see INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT STEERING PAD ASSEMBLY (see DISPOSAL )
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (see PROBLEM SYMPTOMS TABLE ).
INSPECT STEERING WHEEL POSITION