LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Seat Position Sensor >> Removal

Seat Position Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)  (see REMOVAL )
  3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)  (see REMOVAL )
  4. REMOVE SEAT POSITION AIRBAG SENSOR 
    1. Remove the seat slide position sensor protector from the seat position sensor.
    2. Using a T30 "Torx" socket, remove the "Torx" screw and seat position sensor.
    3. Disconnect the connector.
scientia non olet · About LEMON Manuals