LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Front Passenger Airbag Assembly >> Removal

Front Passenger Airbag Assembly: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY  (see REMOVAL )
  3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY 
    1. Detach the wire harness clamp from bracket.
    2. Disconnect the connector from the airbag.
      NOTE: When handling the airbag connector, do not damage the airbag wire harness.
    3. Remove the 2 bolts from the reinforcement.
    4. Remove the instrument panel upper (See REMOVAL ).
      Fig 1: Disconnecting Airbag Connector
      G05184635Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Release the front side airbag door from the front side hook by slightly bending it and lift out the front passenger airbag rearward.
    6. Release the rear side airbag door from the other hook and remove the front passenger airbag.
scientia non olet · About LEMON Manuals