LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Front Airbag Sensor >> Removal

Front Airbag Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE RADIATOR SUPPORT OPENING COVER 
  3. REMOVE FRONT AIRBAG SENSOR LH 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
    Fig 1: Locating Front Airbag Sensor LH Bolt
    G05184692Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT AIRBAG SENSOR RH 
    1. Disconnect the sensor connector.
    2. Remove the bolt and sensor.
scientia non olet · About LEMON Manuals