LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Supplemental Restraint System) >> Center Airbag Sensor Assembly >> Removal

Center Airbag Sensor Assembly: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (see DATA LIST / ACTIVE TEST ).
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH  (see REMOVAL )
  3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH  (see REMOVAL )
  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY  (see REMOVAL )
  5. REMOVE SWITCH BASE  (see REMOVAL )
  6. REMOVE CONSOLE CUP HOLDER BOX  (see REMOVAL )
  7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY  (see REMOVAL )
  8. REMOVE CONSOLE REAR END PANEL  (see REMOVAL )
  9. REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH  (see REMOVAL )
  10. REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH  (see REMOVAL )
  11. REMOVE REAR CONSOLE BOX ASSEMBLY  (see REMOVAL )
  12. REMOVE CENTER AIRBAG SENSOR ASSEMBLY 
    1. Disconnect the airbag sensor connectors.
    2. Remove the 3 bolts and airbag sensor.
scientia non olet · About LEMON Manuals