Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CENTER AIRBAG SENSOR ASSEMBLY
1. Turn the ignition switch OFF.
2. Disconnect the cable from the negative (-) battery terminal, and wait for at least 90 seconds.
3. Connect the cable to the negative (-) battery terminal, and wait for at least 2 seconds.
4. Turn the ignition switch ON, and wait for at least 60 seconds.
5. Clear the DTCs (see DTC CHECK / CLEAR ).
6. Turn the ignition switch OFF.
7. Turn the ignition switch ON, and wait for at least 60 seconds.
8. Check the DTCs (see DTC CHECK / CLEAR ).
Fig 1: Identifying DLC3 Connector
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: DTC B1000/31 is not output.

NG: REPLACE CENTER AIRBAG SENSOR ASSEMBLY

OK: USE SIMULATION METHOD TO CHECK