Front No. 1 Speaker: Removal

HINT:

• Use the same procedures for the RH side and LH sides.
• The procedures listed below are for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH  (see DISASSEMBLY )
3. REMOVE DOOR ASSIST GRIP COVER LH 
4. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 
5. REMOVE FRONT ARMREST BASE PANEL UPPER LH  (see DISASSEMBLY )
6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (see DISASSEMBLY )
7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY 
   1. Disconnect the connector.
   2. Using a drill bit with a diameter of less than 4 mm (0.16 in.), drill out the 3 rivet heads and remove the speaker.
      NOTE:

      • Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill out the rivet head.
      • Be careful as the cut rivet will be very hot.
   3. Continue drilling and push out the remaining rivet fragments.
   4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.
   Fig 1: Drilling Out Rivet Heads Using Drill

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002