Front No. 1 Speaker: Installation

HINT:

• Use the same procedures for the RH side and LH sides.
• The procedures listed below are for the LH side.

1. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY 
   1. Using an air riveter or hand riveter, install the speaker with 3 new rivets.
      Fig 1: Installing Front No. 1 Speaker Using Hand Riveter

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      • Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.
        Fig 2: Precaution For Prying Rivet With Riveter

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • Confirm that the rivets are seated properly against the speaker.

        Do not tilt the riveter when installing the rivet to the speaker.

        Do not leave any space between the rivet head and speaker.

        Fig 3: Identifying Rivets Installation

        Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • Do not leave any space between the speaker and door. Firmly hold together the 2 items while installing the rivet.
   2. Connect the connector.
2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH  (see REASSEMBLY )
3. INSTALL FRONT ARMREST BASE PANEL UPPER LH  (see REASSEMBLY )
4. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH 
5. INSTALL DOOR ASSIST GRIP COVER LH 
6. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH  (see REASSEMBLY )
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
   Fig 4: Identifying Rivets Installation

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002