Fuel Tank: Reassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FUEL SENDER GAUGE ASSEMBLY
1. Install the sender gauge with the 5 screws.
  Torque: 1.5 N*m (15 kgf*cm, 13 in.*lbf)
  
  Fig 1: Installing Sender Gauge With Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FUEL TANK CUSHION
1. Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.
  
  Fig 2: Installing Fuel Tank Cushions Onto Fuel Tank
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 1 FUEL TUBE CLAMP
1. Install the 4 tube clamps to the fuel tank.
INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
1. Install the tube to the 4 fuel tube clamps (see Fig 3).
INSTALL FUEL SUCTION WITH PUMP ASSEMBLY (See appropriates step(s) under INSTALLATION )
INSTALL FUEL TANK VENT TUBE SET PLATE (See INSTALLATION )
CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY (See INSTALLATION )

Fig 3: Installing Tube To Fuel Tube Clamps
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002