Rear Bumper: Installation

1. Attach the 5 outside moulding retainers to install the moulding.
   Fig 1: Installing Rear Bumper Side Moulding Subassembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures described for the LH side.

1. Attach the claw to install the side retainer.
   Fig 2: Installing Side Retainer

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the screw.

HINT:

Use the same procedures described for the LH side.

1. Attach the claw to install the bumper side support.
2. Install the 2 screws.

Fig 3: Installing Bumper Side Support

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Use the same procedures described for the LH side.

1. Install the bumper reinforcement with the 6 bolts.

   Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

   Fig 4: Installing Bumper Reinforcement With Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Install the reflex reflector with the screw.

HINT:

Use the same procedures described for the LH side.

HINT:

When removing the double-side tape, heat the rear bumper.

Standard heating temperature 

Fig 5: Installing Reflex Reflector With Screw

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Clean the bumper surface.
   1. Using a heat light, heat the bumper surface.
   2. Remove the double-sided tape from the bumper.
   3. Wipe off any tape adhesive residue with cleaner.
2. Install the new bumper protector.
   Fig 6: Installing Bumper Protector

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Put protective tape under the quarter panel.
2. Attach the 12 claws to install the bumper cover.
   Fig 7: Installing Rear Bumper Cover

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the 9 screws and 7 clips.
   Fig 8: Installing Screws And Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002