Front Bumper: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE FRONT FENDER LINER LH
1. Using a screwdriver, remove the fender liner retainer.
2. Remove the screw, nut and bolt.
  
  Fig 1: Removing Screw, Nut And Bolt
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. w/Splash Shield:
  Remove the front fender splash shield LH.
4. Partially remove the fender liner.
  HINT:
  
  It is not necessary to fully remove the fender liner. Partially remove it so that the bumper cover can be removed later.
REMOVE FRONT FENDER LINER RH
HINT:

Use the same procedures described for the LH side.
REMOVE RADIATOR SUPPORT OPENING COVER
1. Remove the 2 clips.
2. Partially remove the radiator support opening cover.
  HINT:
  
  It is not necessary to fully remove the radiator support opening cover. Partially remove it so that the bumper cover can be removed later.
  
  Fig 2: Removing Radiator Support Opening Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE RADIATOR GRILLE PROTECTOR
1. Remove the 2 radiator grille protectors.
  
  Fig 3: Removing Radiator Grille Protectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER COVER
1. Remove the 8 screws.
  
  Fig 4: Removing Front Bumper Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Apply protective tape under the front fender and headlight.
3. Using a screwdriver, detach the 4 claws.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 5: Removing Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. w/Fog Light:
  Disconnect the 2 fog light connectors.
5. Using a clip remover, remove the hood cushion center.
  
  Fig 6: Removing Hood Cushion Center
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Using a clip remover, remove the 4 clips and remove the front bumper cover.
  
  Fig 7: Removing Front Bumper Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE NO. 2 FRONT BUMPER ENERGY ABSORBER
1. Remove the absorber.
  
  Fig 8: Removing No. 2 Front Bumper Energy Absorber
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER RETAINER
1. Remove the bolt and retainer.
  
  Fig 9: Removing Front Bumper Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER REINFORCEMENT SUBASSEMBLY
1. Detach 5 clamps and remove the wire harness.
  
  Fig 10: Removing Wire Harness
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 8 bolts and reinforcement.
  
  Fig 11: Removing Bolts And Reinforcement
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FRONT BUMPER SIDE RETAINER LH
1. Remove the bolt.
2. Using a screwdriver, detach the clip and remove the bumper side retainer.
  HINT:
  
  Tape the screwdriver tip before use.
REMOVE FRONT BUMPER SIDE RETAINER RH
HINT:

Use the same procedures described for the LH side.

Fig 12: Removing Bumper Side Retainer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002