LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 126 (Exterior) >> Front Bumper >> Disassembly

Front Bumper: Disassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY 
    1. Remove the 4 bolts and 4 nuts.
      Fig 1: Removing Radiator Grille Sub-Assembly (1 Of 2)
      G04492202Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Detach the 6 claws and remove the radiator grille.
      Fig 2: Removing Radiator Grille Sub-Assembly (2 Of 2)
      G04492203Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE NO. 1 RADIATOR GRILLE LOWER 
    1. Detach the 18 claws and remove the radiator grille.
      Fig 3: Removing Claws And No. 1 Radiator Grille
      G04492204Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE NO. 2 RADIATOR GRILLE LOWER 
    1. Detach the 16 claws and remove the radiator grille.
      Fig 4: Removing Claws And No. 2 Radiator Grille
      G04492205Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE FRONT BUMPER ARM HOLE COVER LH 
    1. Detach the 2 claws and disconnect the arm hole cover.
    2. Remove the hook and bumper arm hole cover.
  5. REMOVE FRONT BUMPER ARM HOLE COVER RH 
    1. Use the same procedures described for the LH side.
      Fig 5: Removing Claws And Arm Hole Cover
      G04492206Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE FOG LIGHT ASSEMBLY LH 
    1. Remove the screw and fog light.
    2. Remove the 3 bolts and fog light mounting bracket.
    Fig 6: Removing Fog Light Mounting Bracket
    G04492207Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE FOG LIGHT ASSEMBLY RH 

    HINT:

    Use the same procedures described for the LH side.

  8. REMOVE FRONT BUMPER HOLE COVER LH (w/o Fog Light) 
    1. Remove the 3 bolts, bumper hole cover and fog light mounting bracket.
      Fig 7: Removing Bumper Hole Cover And Fog Light Mounting Bracket
      G04492208Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE FRONT BUMPER HOLE COVER RH (w/o Fog Light) 

    HINT:

    Use the same procedures described for the LH side.

  10. REMOVE FRONT BUMPER EXTENSION LH (for Wide Body) 
    1. Detach the 7 outside moulding retainers and remove the extension LH.
      NOTE:
      • If reusing the extension, take care not to damage the extension.
      • Be careful not to damage the vehicle body.
      Fig 8: Removing Outside Moulding Retainers And Extension LH
      G04492209Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  11. REMOVE FRONT BUMPER EXTENSION RH (for Wide Body) 

    HINT:

    Use the same procedures described for the LH side.

scientia non olet · About LEMON Manuals