Rear Shock Absorber: Disposal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISPOSE OF REAR SHOCK ABSORBER ASSEMBLY LH
1. Fully extend the shock absorber rod, and clamp it in a vise at an angle.
2. Using a drill, make a hole near the center of the cylinder in the hatched area shown in the illustration to discharge the gas inside.
  
  Fig 1: Discharging Gas Inside Rear Shock Absorber At Shaded Area
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  CAUTION:
  As metal debris may be blown outward by the gas, you must:
  - Wear protective glasses.
  - Cover the area being cut.
  NOTE: The gas is colorless, odorless and harmless.