FRONT SHOCK ABSORBER WITH COIL SPRING (for Sport Package): Disposal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY LH
1. Fully extend the shock absorber piston rod, and clamp it in a vise at an angle.
2. Using a drill or similar tool, gradually make a hole in area A to discharge the gas inside of the absorber.
  CAUTION: As metal debris may be blown outward by the gas, you must.
  - Wear protective glasses.
  - Cover the area being cut.
    NOTE: The gas is colorless and harmless.
    
    Fig 1: Discharging Gas From Strut At Area A
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002