Rear Door: Adjustment

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
Centering bolts are used to mount the door hinge to the vehicle body and door. The door cannot be adjusted with the centering bolts on. Substitute the centering bolts with standard bolts (with washers) when making adjustments.
A bolt without a torque specification is shown in the standard bolt chart (see SPECIFIED TORQUE FOR STANDARD BOLTS ).

Fig 1: Identifying Centering Bolts With Standard Bolts (With Washers)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
ADJUST REAR DOOR PANEL SUB-ASSEMBLY LH
1. Loosen the body's hinge bolts and adjust the door's position.
2. Tighten the body's hinge bolts after the adjustment.
  Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
  
  Fig 2: Loosening Body's Hinge Bolts And Adjusting Door's Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Loosen the door's hinge bolts and adjust the door's position.
4. Tighten the door's hinge bolts after the adjustment.
  Torque: 26 N*m (265 kgf*cm, 19 ft.*lbf)
  
  Fig 3: Loosening Door's Hinge Bolts And Adjusting Door's Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using a T40 "Torx" socket, adjust the striker position by slightly loosening the striker mounting screws and then hitting the striker with a plastic-faced hammer.
6. Using a T40 "Torx" socket, tighten the striker mounting screws after the adjustment.
Torque: 23 N*m (235 kgf*cm, 17 ft.*lbf)

Fig 4: Tightening Striker Mounting Screws
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL