LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 120 ((Door / Hatch)) >> Front Door >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FRONT DOOR PANEL SUB-ASSEMBLY LH 
    1. Check that the clearance measurements of areas A to J are within the standard range.
      Fig 1: Checking Front Door Panel Clearances
      G04492022Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard measurement 

      STANDARD MEASUREMENT SPECIFIED AREA (FRONT DOOR)

      Area Specified Condition Area Specified Condition
      A 6.2 +- 1.5 mm (0.244 +- 0.059 in.) F 3.9 +- 1.5 mm (0.154 +- 0.059 in.)
      B 5.3 +- 1.5 mm (0.209 +- 0.059 in.) G 9.8 +- 1.5 mm (0.386 +- 0.059 in.)
      C 6.3 +- 1.5 mm (0.248 +- 0.059 in.) H 5.1 +- 1.5 mm (0.201 +- 0.059 in.)
      D 5.3 +- 1.5 mm (0.209 +- 0.059 in.) I 0.0 +- 1.5 mm (0.000 +- 0.059 in.)
      E 4.5 +- 1.5 mm (0.177 +- 0.059 in.) J 4.5 +- 1.5 mm (0.177 +- 0.059 in.)
scientia non olet · About LEMON Manuals