On-Vehicle Inspection

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT BACK DOOR

Check that the clearance measurements of areas A to F are within the standard range.

Fig 1: Checking Back Door Clearances

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard measurement

STANDARD MEASUREMENT SPECIFIED AREA (BACK DOOR)

Area	Specified Condition	Area	Specified Condition
A	7.6 +- 1.5 mm (0.299 +- 0.059 in.)	E	5.8 +- 1.5 mm (0.228 +- 0.059 in.)
B	1.0 +- 1.5 mm (0.039 +- 0.059 in.)	F	5.7 +- 1.5 mm (0.224 +- 0.059 in.)
C	5.6 +- 1.5 mm (0.220 +- 0.059 in.)	G	6.1 +- 1.5 mm (0.240 +- 0.059 in.)
D	6.1 +- 1.5 mm (0.240 +- 0.059 in.)	-	-