LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 119 (Engine Fuel System (2AZ-FE)) >> Fuel Tank >> Reassembly

Fuel Tank: Reassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Install the sender gauge with the 5 bolts.

      Torque: 1.5 N.m (15 kgf.cm, 13 in.lbf) 

      Fig 1: Installing Sender Gauge With Bolts
      G04485506Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL NO. 1 FUEL TANK CUSHION 
    1. Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.
      Fig 2: Installing Fuel Tank Cushions Onto Fuel Tank
      G04485507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSTALL NO. 1 FUEL TUBE CLAMP 
    1. Install the 4 tube clamps to the fuel tank.
  4. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY 
    1. Install the tube with the 4 clips.
      Fig 3: Installing Tube With Clips
      G04485508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY (See appropriate step(s) under  INSTALLATION  ) 
  6. INSTALL FUEL TANK VENT TUBE SET PLATE (See appropriate step(s) under  INSTALLATION  ) 
  7. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY (See appropriate step(s) under  INSTALLATION  ) 
scientia non olet · About LEMON Manuals