Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Check the condition of each related circuit connector before troubleshooting (see ELECTRONIC CIRCUIT INSPECTION PROCEDURE ).

CHECK FOR DTC

Clear the DTC (see DTC CHECK / CLEAR ).
Turn the ignition switch OFF.

Turn the ignition switch ON and check that can communication system DTC is not output.

Result

RESULT

Result	Proceed to
CAN communication system DTC is output	A
Engine control DTC is output	B

B: GO TO ENGINE CONTROL SYSTEM:

For 2AZ-FE, see ENGINE CONTROL SYSTEM (2AZ-FE) .

For 2GR-FE, see ENGINE CONTROL SYSTEM (2GR-FE) .

A: GO TO CAN COMMUNICATION SYSTEM