Heated Oxygen Sensor: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL HEATED OXYGEN SENSOR (for Sensor 2)
1. Using SST, install the sensor to the exhaust pipe.
  SST 09224-00010
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use with SST
  
  44 N*m (449 kgf*cm, 32 ft.*lbf) for use without SST
  
  Fig 1: Installing Sensor To Exhaust Pipe
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  - Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).
  - Make sure SST and a wrench are connected in a straight line.
2. Connect the sensor connector.
3. Bank 1 Sensor 2:
  Install the rear console box (see appropriate step(s) under INSTALLATION also refer to Figure).
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
CHECK FOR EXHAUST GAS LEAKS