Section 113 (Emission Control System (2GR-FE)): Canister: Removal

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
REMOVE CANISTER
NOTE: Remove any dirt or foreign objects before performing this work.
1. Disconnect the 2 tubes, hose and connector.
  1. Using a screwdriver, pry up the retainer. (See Fig 1).
    HINT:
    
    Do not remove the retainer.
  2. Disconnect the purge line hose.
  3. Disconnect the air inlet line tube from the canister.
  4. Disconnect the vent line tube from the canister (leak detection pump).
  5. Disconnect the connector from the canister (leak detection pump).
    
    Fig 1: Prying Up Retainer Using Screwdriver
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 4 bolts, clip and canister.
  
  Fig 2: Removing Clip And Canister Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002