Ventilation Valve: Installation

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL VENTILATION VALVE SUB-ASSEMBLY
1. Apply adhesive to 2 or 3 threads of the ventilation valve.
  Adhesive: Toyota genuine adhesive 1324, three bond 1324 or equivalent
  
  Fig 1: Applying Adhesive To Ventilation Valve Threads
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 22 mm deep socket wrench, install the ventilation valve.
  Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf)
  
  Fig 2: Installing Ventilation Valve
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the ventilation hose.
INSTALL NO. 1 ENGINE COVER (See appropriate step(s) under INSTALLATION )
CHECK FOR ENGINE OIL LEAKS