POWER TRANSISTOR (W/ Rear Cooler): Installation
WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL POWER TRANSISTOR
- Install the power transistor with the 2 screws.
- INSTALL QUARTER TRIM PANEL RH
- INSTALL REAR FLOOR MAT SUPPORT PLATE
- INSTALL REAR DOOR SCUFF PLATE RH
- CONNECT BATTERY NEGATIVE TERMINAL
- PERFORM INITIALIZATION
- Perform initialization (see INITIALIZATION
).NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
- Perform initialization (see INITIALIZATION
).