LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> FJ Cruiser RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 11 (Air Conditioning) >> POWER TRANSISTOR (For Rear Heater) >> Installation

POWER TRANSISTOR (For Rear Heater): Installation

WARNING: This page is about a different car, the 2006 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL POWER TRANSISTOR 
    1. Install the power transistor with the 2 screws.
    2. Connect the connector.
  2. INSTALL CENTER PILLAR GARNISH RH 
  3. INSTALL REAR DOOR SCUFF PLATE RH 
  4. INSTALL COWL SIDE TRIM RH 
  5. INSTALL FRONT DOOR SCUFF PLATE RH 
    Fig 1: Installing Power Transistor With Screws
    G04440604Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. INSTALL LOWER CENTER CLUSTER FINISH PANEL 
  7. INSTALL FRONT CONSOLE UPPER PANEL 
  8. INSTALL FRONT CONSOLE BOX 
  9. INSTALL REAR CONSOLE BOX 
  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  11. PERFORM INITIALIZATION 
    1. Perform initialization (see INITIALIZATION ).
      NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
scientia non olet · About LEMON Manuals