Transmission Wire: Inspection

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TRANSMISSION WIRE

Measure the resistance of the transmission wire.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Specified Condition
1 (THO) - 6 (E2)	90 Ω to 156 kΩ
1 (THO) - Body ground	1 MΩ or higher
6 (E2) - Body ground	1 MΩ or higher

If the result is not as specified, replace the wire.

HINT:

If the resistance is not as specified for either of the ATF temperatures shown in the table below, the drivability of the vehicle may decrease.

Standard resistance

ATF TEMPERATURE SPECIFIED CONDITION CHART

ATF Temperature	Specified Condition
10°C (68°F)	6.4 kΩ
110°C (230°F)	0.2 kΩ

Fig 1: Identifying Transmission Wire Connector