Park / Neutral Position Switch: Adjustment

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Loosen the 2 bolts of the switch and set the shift lever to the N position.
2. Align the groove and neutral basic line.
3. Hold the switch in this position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. Perform the inspection (see ON-VEHICLE INSPECTION ).
  
  Fig 1: Aligning Groove And Neutral Basic Line
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002