Oil Pump: Reassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST and a hammer, tap in a new oil seal to the oil pump body.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flat with the outer edge of the oil pump.
2. Coat the lip of the oil seal with MP grease.
  
  Fig 1: Installing Front Oil Pump Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF, and install it to the oil pump body.
  NOTE:
  - Make sure that the O-ring is not twisted or pinched.
  - Apply enough ATF to the O-ring before installation.
    
    Fig 2: Installing Front Oil Pump Body O-Ring
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 3: Installing Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the marked side facing upward.
  
  Fig 4: Installing Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set the stator shaft and align it with each bolt hole.
2. Using a T30 "torx" socket, install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Identifying 11 Torx Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
1. Coat 2 new oil seal rings with ATF.
2. Install 2 new clutch drum oil seal rings.
  NOTE: Do not expand the ring ends excessively.
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )

Fig 6: Installing Clutch Drum Oil Seal Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002