Inspection Procedure

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLT)

Disconnect the B32 wire connector.

Measure the resistance of the transmission wire.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Condition	Specified Condition
2 (SLT+) - 8 (SLT-)	20°C (68°F)	5.0 to 5.6 Ω
2 (SLT+) - Body ground	20°C (68°F)	1 MΩ or higher
8 (SLT-) - Body ground	20°C (68°F)	1 MΩ or higher

NG: Go to step 3

Fig 1: Identifying B32 Wire Connector

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: Go TO NEXT STEP.

CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM)

Disconnect the B30 ECM connector.

Measure the resistance of the wire harness side connector.

Standard resistance

STANDARD RESISTANCE

Tester Connection	Condition	Specified Condition
B30-11 (SLT+) - B30-10 (SLT-)	20°C (68°F)	5.0 to 5.6 Ω
B30-11 (SLT+) - Body ground	20°C (68°F)	1 MΩ or higher
B30-10 (SLT-) - Body ground	20°C (68°F)	1 MΩ or higher

NG: REPAIR OR REPLACE HARNESS AND CONNECTOR

Fig 2: Identifying B30 ECM Connector

OK: REPLACE ECM

INSPECT SHIFT SOLENOID VALVE SLT
1. Remove the shift solenoid valve SLT.
2. Measure the resistance of the solenoid valve.
  Standard resistance: 5.0 to 5.6 Ω at 20°C (68°F)
3. Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
  OK: Valve moves and makes operating noise.
NG: REPLACE SHIFT SOLENOID VALVE SLT

Fig 3: Inspecting Shift Solenoid Valve
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPAIR OR REPLACE TRANSMISSION WIRE