Park / Neutral Position Switch: Adjustment

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY
1. Loosen the 2 bolts of the switch and set the shift lever to the N position.
2. Align the groove and neutral basic line.
3. Hold the switch in this position and tighten the 2 bolts.
  Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)
4. After adjustment, perform the inspection (see DTC P2769 TORQUE CONVERTER CLUTCH SOLENOID CIRCUIT LOW (SHIFT SOLENOID VALVE DSL); DTC P2770 TORQUE CONVERTER CLUTCH SOLENOID CIRCUIT HIGH (SHIFT SOLENOID VALVE DSL) ).
  
  Fig 1: Loosening Bolts Of Switch And Setting Shift Lever To N Position
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002