Oil Pump: Reassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL FRONT OIL PUMP OIL SEAL
1. Using SST, install a new oil seal to the pump.
  SST 09350-32014 (09351-32140)
  
  HINT:
  
  The seal end should be flush with the outer edge of the oil pump.
2. Coat the lip of the oil seal with petroleum jelly.
  
  Fig 1: Installing Front Oil Pump Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP BODY O-RING
1. Coat a new O-ring with ATF, and install it to the oil pump body.
  
  Fig 2: Installing O-Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVEN GEAR
1. Coat the front oil pump driven gear with ATF, and install it to the oil pump body with the maked side facing up.
  
  Fig 3: Installing Front Oil Pump Driven Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT OIL PUMP DRIVE GEAR
1. Coat the front oil pump drive gear with ATF, and install it to the oil pump body with the maked side facing up.
  
  Fig 4: Installing Front Oil Pump Drive Gear
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STATOR SHAFT ASSEMBLY
1. Set stator shaft by aligning each bolt hole.
2. Using a T30 "torx" socket, install the 11 bolts.
  Torque: 9.8 N*m (100 kgf*cm, 87 in.*lbf)
  
  Fig 5: Installing Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CLUTCH DRUM OIL SEAL RING
NOTE: Do not expand the ring ends excessively.
1. Install the 2 clutch drum oil seal rings.
INSPECT OIL PUMP ASSEMBLY (See INSPECTION )

Fig 6: Installing Clutch Drum Oil Seal Rings
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002