Forward Clutch: Disassembly

WARNING: This page is about a different car, the 2007 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT PACK CLEARANCE OF FORWARD CLUTCH (See INSPECTION )
REMOVE FORWARD MULTIPLE DISC CLUTCH DISC
1. Using a screwdriver, remove the snap ring.
  
  Fig 1: Removing Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the flange, 5 discs and 5 plates.
INSPECT FORWARD MULTIPLE DISC CLUTCH DISC (See INSPECTION )

Fig 2: Removing Flange, Discs And Plates
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY
1. Place SST on the spring retainer and compress the return spring with a press.
  SST 09350-32014 (09351-32070)
2. Using a snap ring expander, remove the snap ring.
  
  Fig 3: Removing Snap Ring
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Remove the piston return spring.
INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY (See INSPECTION )

Fig 4: Removing Piston Return Spring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE FORWARD CLUTCH PISTON SUBASSEMBLY
1. Place the forward clutch drum onto the oil pump.
2. Holding the forward clutch piston with your hand, apply compressed air (392 kPa, 4.0 kgf/cm² , 57 psi) to the oil pump to remove the forward clutch piston.
  
  Fig 5: Applying Compressed Air To Oil Pump
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  When the piston is slanted and cannot be removed, remove it by pushing down the protruding side and applying compressed air again, or using need-nose pliers (with its tips wrapped in tape).
REMOVE FORWARD CLUTCH PISTON O-RING
1. Remove the 2 O-rings.
INSPECT FORWARD CLUTCH PISTON SUBASSEMBLY (See INSPECTION )

Fig 6: Removing O-Rings
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INPUT SHAFT OIL SEAL RING

Fig 7: Removing Input Shaft Oil Seal Ring
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002